BIOS Setup Utility
SY-7IZB+N
49
Down
1-15Min When the set time has
elapsed, BIOS sends a
command to the HDD to
power down. This turns off
the HDD motor.
Some older
model HDDs
may not support
this advanced
function.
3-5.3 PM Events
PM Events Setting Description Note
Disabled
PCI/VGA Act-
Monitor
Enabled Enables the power
management timers when a
[no activity] event is detected.
Default
Disabled Default
IRQ 8 Break
Suspend
Enabled Alarm function is active.
3-5.4
Reload Global Timer Events
Power Down
& Resume
Events
Setting Description Note
Disabled
IRQ
[3-7,9-15],
NMI
Enabled The system monitors these
elements for activity. The
system will resume if [IRQ
activity] is detected.
Default
Disabled DefaultIDE0, IDE1
Primary
Secondary
Enabled Enables the PM timers when
[No Activity Event] is detected.
Disabled DefaultFloppy Disk
Serial Port
Parallel Port
Enabled Enables the PM timers when
[No Activity Event] is detected.