SY-P4VGM V1.0 Quick Start Guide
13
Quick BIOS
Setup
3
3
Quick BIOS Setup
After the hardware installation is complete, turn the power switch on, then press the
<DEL>
key during the system diagnostic checks to enter the Award BIOS Setup program. The
CMOS SETUP UTILITY will be shown on the screen. Then, follow these steps to configure
the CPU settings.
Step 1. Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.
Step 2. Select [LOAD OPTIMIZED DEFAULTS]
Select the “LOAD OPTIMIZED DEFAULTS” menu and type “Y” at the prompt to load the
BIOS optimal setup.
Step 3. Select [SAVE & EXIT SETUP]
Press
<Enter>
to save the new configuration to the CMOS memory, and continue the
boot sequence.
To Next Page
Loading...
Need help?
General
