ASSEMBLE
1. VERIFY POWER SWITCH
IS IN THE OFF POSITION
2. INSTALL DRIVE SHAFT
Place drive shaft
gasket on drive shaft
Seal gasket open
space with Spaceman
lubricant, extending
onto drive shaft and
avoiding the top
square part
Insert drive shaft into rear
shell bearing at the back of
the cylinder, and turn it until
the key engages firmly into
the socket (when inserted
correctly, the drive shaft will
no longer turn 360°)
1
2a
2b
2c
Spaceman USA 6210 Training rev111918
To Next Page
Loading...
