Spaceman 6210 - Final Product Loading Steps

FROZEN PRODUCT OPERATION
7
ADD PRODUCT TO MACHINE
Pour remaining
product into hopper
Raise the prime
plug on the top of
the dispensing
door until flow is
100% product
Push prime plug
back down
Wash air tube and
cap; install air tube
in hopper (inlet hole
on side of air tube at
bottom)
Replace hopper lid
11
10
9
8
Product is now
ready to freeze
12
NOTE: The mix-low lights illuminate RED when a hopper is low on product mix and
automatically de-illuminate when machine is filled.
Spaceman USA 6210 Training rev111918