FROZEN PRODUCT OPERATION
I. FREEZE PRODUCT
Verify cylinder is full of mixed product and primed
Turn power switch to FREEZE position
The motor will begin to agitate the product,
and the cooling system will begin to freeze
the product
Freezing product takes approximately 10 minutes
When product reaches the set viscosity, it is
ready to dispense (viscosity can be changed in
the Settings menu, Page 19)
IMPORTANT
Machine shuts down automatically if cylinder experiences freeze-
up (usually because the viscosity is set too high for the selected
product) to prevent motor damage. Use the green reset button to
return the machine to normal operation.
PROPER MACHINE RESET
1. Switch power switch OFF
2. Press green reset button on side or back of machine
3. Wait 15 to 20 minutes; switch power ON
4. Press RESET, then WASH button on front
5. Observe machine performance and return to normal use if
functioning properly
CAUTION:
If machine makes any abnormal noise during reset,
immediately switch power OFF and contact service
NOTE:
If machine doesn't turn on, turn power OFF, wait 30 minutes, and
repeat steps 1 to 5. If problem persists, contact service team.
Spaceman USA 6210 Training rev111918
To Next Page
Loading...
