FROZEN PRODUCT OPERATION
Maintain product consistency
Machines without air pumps can
experience product consistency
changes if they go unused for an
extended period of time. Product may
become icy or dense if left in the
freezing cylinder too long, often
occurring during a business’s longer
slow-periods.
With machine in FREEZE mode, remove air tube
1
Clean air tube and insert into machine upside-down
(inlet hole on the side of the air tube at the top)
2
Confirm product is above low-mix line in hopper
3
Open draw handle to draw 6 to 8 oz. of product; discard product
4
Wait until machine finishes freeze cycle and motor stops turning
5
Remove and clean air tube
6
Insert air tube into machine with correct orientation (inlet hole
on the side of the air tube at the bottom)
7
Machine is ready for normal operation
8
Spaceman USA 6210 Training rev111918
To Previous Page
Loading...
