Page 10 Seaich Corporation, LLC. All rights reserved. www.seaich.com
|
Spacerails, LLC. www.spacerails.com
CUT THE RAIL TO SIZE
Step 1: Measure each section and mark the cutting point with a pen.
Step 2: Cut each section according to your measurement. Make sure
to cut at a 90° angle.
Tip: To help avoid do-overs and using too much rail, cut generously
(slightly longer than required) to begin with. You can always cut a
long rail shorter.
NOTES:
Illustration of rail lengths is
approximately 5% in scale.
Measure carefully and use a tape
measure for longer segments.
See included insert for rail
measurements in 1:1 scale.
G
A
5cm
B
45cm
45cm
C
200cm
200cm
D
E
F
G
350cm
To Next Page
Loading...
