BACK-UP BATTERY
The bed comes with internal or
External Battery Back-up option.
The Back-up Battery is for use
when there is a power outage, or
the bed needs to be operated
where there is no power source
nearby. An optional Back-up
Battery Extension Cord and
Charger is available that allows
easy access to the battery port on
the Control Box. The Extension
Cord Socket is mounted under the
seat deck on the side of the bed.
EXTERNAL BACK-UP BATTERY USAGE
Plug the Charger into a 120 V socket; keep the battery charger plugged in when not in use to maintain a full
charge. To use the Back-Up Battery:
1. disconnect the battery from the
charger, and take it to the bed(s).
2. If there is a Battery Extension
Cord on the side of the bed, plug
the battery plug into the Socket,
and operate the bed normally.
3. If there is no Extension Cord,
connect the battery Plug into the
Back-up Battery Port of the
Controller box, and use the bed
normally.
4. When complete, return the
Back-up Battery to its original
location, and plug in the charger.
IMPORTANT! Depending on the location of the beds within the Healthcare Facility, it is
recommended that at least one Battery-Pack is needed for 1-5 beds with an additional Battery-Pack
for each additional 5 beds. Depending on the layout of the Healthcare Facility more or less Battery-
Packs might be needed. The Healthcare Facility is responsible for matching the number of Batteries to
the number of beds in compliance with Medical Protocols, Agency and Regulatory guidelines.
To Next Page
Loading...
