3
SETUP 11
SETUP
ASSEMBLING THE SHARPENER
To watch the How-To video, visit sparxhockey.com/assembly.
1 INSTALL THE CLAMP LEVER
Slide the Clamp Lever (A) onto the Lever Dock (B). Press the
lever down until it clicks into place. When the Clamp Lever is
engaged, it will lay at a slight angle.
A
B
2 REMOVE THE TRAVEL GUARD
Open the Skate Clamp by pressing and holding down the Clamp
Lever. Remove the Travel Guard. Release the Clamp Lever.
Do not discard the Travel Guard. This guard is
used to keep the components of the sharpener
safe during travel. Damage resulting from
transport without the Travel Guard installed is not
covered by warranty.
3 PLUG IN THE POWER CORD
Plug the Power Cord into the Power Input Port on the back of
the sharpener. Plug the other end into a wall outlet. Toggle the
switch on the Power Input Port to the on position (I=on, 0=o).
1
2
A
To Next Page
Loading...