Wire Trap
This is located under the front hood. It must not be interfered with in any way
Any wire must be removed immediately.
Lower rotor to ground, select rotor control lever to ‘off’ and wait until rotor stops
spinning. Disengage P.T.O. and stop engine before leaving cab.
High voltage cables
Always be very aware of overhead cables. Between poles wires can be
well within reach of the machine. If in any doubt of the danger, consult
your local electricity company regarding a safe procedure for work.
Oil Cooler
Prolongs the life of the hydraulic oil and components
in hot and arduous conditions.
Wire is extremely dangerous and must be
avoided at all times. Inspect work area before
commencing, removing all loose wire and clearly
marking fixed wire
For machines fitted with an oil cooler it is
important to connect a separate lead direct
from the battery to the oil cooler control
Excel 606, 686, 726 & 836
To Next Page
Loading...
