Attaching your machine to the tractor – using
axle mounting
Follow instructions from Picture 1. if you have axle mounting.
Follow instructions from Picture 9. if you have 3 point linkage mounting
It is most important the operator fully understands the procedure for
attaching/unattaching the reach mower to/from the tractor. The
following text must be fully understood before attempting to attach the
machine. If there is any doubt please contact your supplying dealer or
Spearhead Service Department. Failure to follow the correct procedure
To attach/unattached the machine could result in personal injury or machine damage. Any
resulting damage to a machine is not covered by warranty.
Always be sure to select a level firm surface, such as concrete before attaching to the tractor.
When operating the tractor or machine’s controls do so only when seated in the tractor cab.
Do not allow anyone to stand on or amongst linkage for any reason.
1. Mount axle brackets as instructed on
separate fitting sheet specific to your
tractor type.
2. Detach tractor draft links.
Excel 606, 686, 726 & 836
To Next Page
Loading...