Specialized AETHOS - 5.4. Disc Brakes

14
5.4. DISC BRAKES
FIG. 1: Route the rear brake housing.
• Run the rear brake housing in through the chainstay ICR port, over the bottom bracket shell, up the
down tube.
• Install a Churro (foam sleeve) over the brake housing and into the down tube.
• Route the brake housing out the head tube ICR port.
• Install a grommet over the brake housing and into the head tube ICR port.
• Install the caliper on the chainstay. Complete the rear brake installation according to the brake
manufacturer’s instructions.
FIG. 1: Route the front brake housing.
• Run the front brake housing in through the lower ICR port in the fork and guide it up the fork leg until
it exits at the ICR port on the fork crown.
• Install a grommet over the brake housing and into the upper fork ICR port.
• FIG. 1a: Install the caliper on the Specialized Flat Mount front brake adapter (A), then bolt the
adapter to the fork mount holes (B).
FIG. 1a: Only use the Specialized Flat Mount front brake adapter
(S200700001) on the Aethos fork.
• Complete the front brake installation according to the brake manufacturer’s instructions.