Specialized COMO - 12. DRIVETRAIN WITH ENVIOLO HUB; 12.1. REMOVING AND RE-INSTALLING THE ENVIOLO EQUIPPED REAR WHEEL

36
ENITESPTCNTCNSJP KR
12. DRIVETRAIN WITH ENVIOLO HUB
12.1 a 12.1 b
Fig. 12.1 (A-B)
Some Como models are equipped with the enviolo internal geared hub. Depending on the model,
the bike is equipped with either a manual hub interface (A) or the AUTOMATiQ hub interface (B),
which is integrated into the Como system displaying the essential information on the MasterMind
TCD-w.
AUTOMATiQ Bicycles:
The enviolo stepless automatic technology takes the ride experience to the next level with its ‘set
it and forget it’ approach.
Cyclists only need to set up their desired cadence, and the stepless automatic technology will
adjust the enviolo system so that they can always pedal at the same pace, up or downhill.
NOTE: Technical limitations apply and the gear ratio is eventually limited depending on rider
preference, terrain or cadence.
INFO: For information on maintenance and usage of the enviolo IGH visit the
manufacturer’s website.
For information on maintenance and usage of the Gates Carbon Drive™ belt
system, visit www.GatesCarbonDrive.com/OwnersManual.
INFO: Non-enviolo IGH equipped Como models are not compatible with an
enviolo IGH.
WARNING! Due to the high degree of complexity of the IGH, proper assembly
of the hub requires a high degree of mechanical ability, skill, training, and
specialty tools. Therefore, it is essential that the assembly, maintenance, and
troubleshooting be performed by an Authorized Specialized Retailer.
12.1. REMOVING AND RE-INSTALLING THE ENVIOLO EQUIPPED REAR WHEEL
REMOVE THE REAR WHEEL (ENVIOLO AUTOMATIQ IGH)
B
C
C
B
A
12.2