Speco NRL - Buzzer; Push Message; Manual Alarm; View Alarm Status

Alarm Management
NVR User Manual
49
and the pop-up message box. Click “Apply” to save the settings.
9.5.4 Buzzer
Click StartSettingsAlarmEvent NotificationBuzzer to go to the buzzer configuration interface. Set the delay time of the buzzer and then click
“Apply” to save the setting. You can click “Test” to test the buzzer.
9.5.5 Push Message
Click StartSettingsAlarmEvent NotificationPush Message to go to the interface as shown below. Check “Enable” and then click “Apply”
button to save the settings. If Push Server is online, it will push messages to the mobile clients.
9.6 Manual Alarm
Click on the tool bar at the bottom of the live view interface to pop up a window. Click “Trigger” to start alarm. Click “Clear” to stop alarm.
9.7 View Alarm Status
Click StartSettingsAlarmAlarm Status or click on the tool bar at the bottom of the live view interface to view the alarm status.