CHARGING & BATTERIES (CONTINUED 2)
8
LL300S, HV302, HV302G, GL422N (Rechargeable Battery Pack)
● The Spectra LL300S, HV302, HV302G and GL422N are all powered by the Spectra Precision
SBP10 10,000mAH NiMH rechargeable battery pack which will be pre-installed in the base of
the laser.
● The battery pack contains 4 x 1.2V NiMH 10,000mAH rechargeable batteries. This battery
pack must never be opened.
● Prior to fi rst use, we recommend that you fully charge the battery pack for around 7-8 hours.
● The LL300S & HV302 battery pack will give around 45 hours of continuous use.
● The HV302G battery pack will give around 30 hours of continuous use.
● The GL422N battery pack will give around 35 hours of continuous use.
● Important: Do NOT allow battery to go completely fl at before recharging.
Rechargeable Battery Pack Removal Procedure
● Turn the laser over.
● Twist the central battery latch through 90 degrees to remove the battery cover, noting its
orientation. No tool is required for removal; its just fi nger-tight.
● Withdraw the battery pack.
● NEVER remove the individual cells from the black battery cradle.
Refi tting Rechargeable Battery Pack Procedure
● Refi tting is the opposite to the above procedure and the battery pack will only fi t into the
laser’s body, one way round.
● An important safety feature on these Spectra lasers only allows the Charger to operate when
the rechargeable battery pack is fi tted.
To Next Page
Loading...
Need help?
General
