22 REFERENCE & INSTALLATION MANUAL
6.5.3 DELETING ASSIGNED REMOTE CONTROLS
Sections [731] to [738]: Remote Controls 1 to 8 respectively
6.5.4 ASSIGNING REMOTE CONTROLS TO USER ACCESS CODES
Sections [701] to [708]: Remote Controls 1 to 8 respectively
Each remote control must be assigned to a User Access Code. All User Access Codes are given a User Number from
001 to 048. Enter the desired User Number in a section from [701] to [708] that represent the remote control assigned
in sections [731] to [738] (refer to Assigning a Remote Control to the Spectra 1759EX on page 21). For example, the
remote control assigned in section [731] will be assigned to the User Access Code designated in section [701].
6.5.5 PROGRAMMING THE REMOTE CONTROL BUTTONS
Sections [711] to [718]: Remote Controls 1 to 8 respectively
Each remote control can be programmed to perform up to 8 different actions. Each digit in sections [711] to [718]
represents a button or combination of buttons (refer to Table 7 on page 23). When a user arms or disarms using the
remote control, the control panel will arm or disarm all the areas assigned to the User Access Code (see Assigning
Remote Controls to User Access Codes on page 22). Sections [711] to [718] represent the remote controls assigned to
sections [731] to [738] (refer to Assigning a Remote Control to the Spectra 1759EX on page 21). For example, the
buttons for the remote control assigned in section [731] will be programmed in section [711].
The User Code assigned to the remote control (refer to Assigning Remote Controls to User Access Codes
on page 22) must have the same User Options enabled. For example, if you enable the Force Arming
button option, you must enable the appropriate Force Arming user option. Also, if you enable any
Panic button options, you must enable the Panic options in the control panel (refer to Keypad Panic
Options on page 27).
How Do I Delete a Remote Control?
1) Press the [ENTER] key.
2) Enter your [INSTALLER CODE].
3) Enter the desired [SECTION NUMBER] (from sections [731] to [738]).
4) Press the [
FORCE] button.
How Do I Assign a Remote Control to a User Access Code?
1) Press the [ENTER] key.
2) Enter your [INSTALLER CODE].
3) Enter the desired [
SECTION NUMBER] (from sections [701] to [708]).
4) Enter the [
USER NUMBER] to be assigned to the remote control (001 to 048).
How Do I Program the Remote Control’s Buttons?
1) Press the [ENTER] key.
2) Enter your [INSTALLER CODE].
3) Enter the desired [SECTION NUMBER] (from sections [711] to [718]).
4) Enter the [
HEXADECIMAL VALUE] (0 to D) of the desired button option from Table 8 in the appropriate space (refer
to Table 7). If you do not wish to program all the buttons or button combinations, simply press the [ENTER] key at
any time to save and exit.
To Next Page
Loading...
