Spectra GL1425C User Manual

©2023 Spectra Precision | All Rights Reserv ed
CR700 pairing with the laser
Start with bringing the CR700 into pairing mode
1. Press (power button) to turn on the CR700
2. Press (menu button).
3. Scroll down to „RDIO“ to display the radio mode:
4. Check if RDIO LS is shown to connect the CR700 with a laser (LS).
5. If yes, proceed with step XX
6. If no, press (enter button). Result: the current RDIO (HL or OF) flashes.
7. Press or button until RDIO LS is blinking.
8. Press (enter button) to enter RDIO LS. Result: RDIO LS stops blinking.
9. Scroll down to „PAIR“.
10. Press (enter button) again. Result: Shows „PAIR“ and a rotating bar.
Switch to laser
11. Make sure laser is turned off.
12. Press and hold (manual button) and press (power button). Result: Battery LED flashes fast.
13. „PAIR OK“ will be displayed. The laser turns back to the standard display.
14. Press (CR700 menu button) once to show the receiver standard display.
15. Result: the receiver display shows the laser and antennna symbol to confirm the radio connection:
or
or
RDIO
LS
RDIO
HL
RDIO
OF
power / menu
scroll up
enter
scroll down

Spectra GL1425C Specifications

General

Brand	Spectra
Model	GL1425C
Category	Measuring Instruments
Language	English