Spectra T950 - Prepare for Maintenance; Gather Required Tools; Ensure ESD Protection

3
HAX and VAX Lubrication Instructions
This guide provides instructions for lubricating the Horizontal Axis (HAX)
and Vertical Axis (VAX) in the Spectra T950 Library.
PREPARE FOR MAINTENANCE
This section describes the tasks required to prepare the library for
maintenance.
Gather Required Tools
You must have the following to complete this procedure:
 1/8-inch Allen wrench or hex screwdriver
 Large binder clip
 Lint-free cleaning wipes
 Isopropyl alcohol
 Foam applicator
 HAX grease (PN 90948180 or 90949130, green or blue in color)
 VAX grease (PN 90948215 or 90949168, white in color)
Ensure ESD Protection
The repair environment for the library must be free of conditions that
could cause electrostatic discharge (ESD). To protect the library from ESD,
follow these procedures when repairing or testing the library:
 Place a static protection mat on the work surface used while removing
and installing library components. Use a 1-megaohm resistor to ground
the static protection mat.
 Wear a static protection wrist band or grounding foot strap whenever
you handle library components that have been removed from their
anti-static bags. Connect the wrist band to the static protection mat or
to other suitable ESD grounding.
 Keep all electronic components in anti-static bags when not in use.
Figure 1 HAX and VAX grease.