Spectra T950 - Lubricate the VAX Linear Rail

HAX and VAX Lubrication Instructions Lubricate the VAX Linear Rail
April 2012 HAX and VAX Lubrication Instructions—Spectra T950 Library
6
LUBRICATE THE VAX LINEAR RAIL
Use the following steps to lubricate the VAX linear rail.
1. While supporting the bottom of the transporter, lift it until it is
positioned near the middle of the VAX column.
2. Use a large binder clip to pinch the two sides of the VAX belt together,
securing the elevated transporter in place.
Note: The VAX belt is the long belt located on the left side of the VAX
column, as viewed from the front of the transporter.
Important
Do not use the front of the transporter carriage or the picker mechanism to lift the
transporter. They are not designed to support the weight of the transporter.
Figure 6 Clamp the VAX belt to hold the transporter.
Vertical axis (VAX)
VAX belt