HAX and VAX Lubrication Instructions Lubricate the VAX Linear Rail
April 2012 HAX and VAX Lubrication Instructions—Spectra T950 Library
7
3. Use the supplied foam applicator to apply four thin, evenly spaced,
1-inch long strips of VAX grease (white, PN 90948215) in the bearing
groove along each side of the VAX linear rail.
Notes: You can use any non-shedding, non-scratching applicator to
apply the grease.
Do not apply an excessive amount of grease. Any excess
grease will be pushed to the top and bottom end of the VAX
linear rail.
4. Use the supplied foam applicator to apply a thin layer of grease to the
top side of the VAX rail to prevent potential oxidation.
Note: You can use any non-shedding, non-scratching applicator to
apply the grease.
Figure 7 Apply four 1-inch strips of VAX grease in the bearing groove along each side of the VAX
linear rail.
VAX linear rail
~1 inch of grease applied
to VAX linear rail
Bearing groove
Figure 8 Apply a thin layer of VAX grease to the VAX rail.
To Next Page
Loading...
