14212650-IG, Edition 1.0
April 2018, Original document
11
Prepare your Handsets and Spectralink
IP-DECT Server 200 for Installation
Before permanently installing Spectralink IP-DECT Server 200s, complete the following steps:
1. Charge the battery in the handsets so the handsets can be subscribed and tested.
For more information, see Handset User Guides.
2. Turn on the Spectralink IP-DECT Server 200(s) and verify the power LED is light is on.
For more information, see "Power Requirements for the Spectralink IP-DECT Server 200" on
page6 and "Spectralink IP-DECT Server 200 LED Indicators" on page9.
3. Subscribe the new handsets to the server(s). Also, if needed, ensure that you have the activ-
ation codes for the handsets ready.
For more information about subscribing the handset and creating Login, see Handset User
Guides.
4. Before physically installing the Spectralink IP-DECT Server 200 onto walls:
l Place the Spectralink IP-DECT Server 200s close to their planned locations.
l Establish test calls between handsets in the areas where they will be used.
l Verify range and sound quality.
l Change the location of the Spectralink IP-DECT Server 200 if necessary to ensure optimal
call coverage and voice quality.
Spectralink IP-DECTServer 200 Deployment and Installation Guide
To Next Page
Loading...
