SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
4
SpectraPure
®
This system is not waterproof. Saltwater damage is not covered in our
five year warranty. Do not let the Pump Module fall into water!
Always run a new pump dry for 20 minutes before putting it into service.
Be sure to observe the rollers revolving around the rotating motor shaft
through the hole in the end of the pump head. See “Servicing The Pump
Module” on Page 12 if the rollers don’t move.
Power
Connection
Air Line Tubing
to High Limit
Sensor Tube
Air Line Tubing
to Primary
Sensor Tube
PUMP CONNECTIONS AND CONTROLS:
Pump Speed LED Indicator Lights
(also indicate seconds pump
runs when in Duty Cycle mode)
Down /Drain
Pump Head
Inspection Hole
Up /Fill
INPUT
(from reservoir)
OUTPUT
to aquarium
Press fit the end of a
piece of 1/4"
polyethylene tubing
into the rubber inlet
hose at
least 3/4".
This is
connected
to the
supply
reservoir.
This
reservoir
needs to be vented to
prevent collapse.
To Next Page
Loading...
