Need help?Do you have a question about the SpectraPure LLC-UPLC-ATO and is the answer not in the manual?
General| Brand | SpectraPure |
|---|---|
| Model | LLC-UPLC-ATO |
| Category | Controller |
| Language | English |
Diagram showing the tubing connections between the reservoir, ATO, and display tank.
Details the required sensor tube positioning for performing the quick setup.
Step-by-step guide on how to initiate the quick setup process by pressing the DOWN button.
Instructs on positioning the primary sensor tube to set the pump's ON and OFF water levels.
Details pressing DOWN to set the lower limit and UP to set the upper limit.
Explains how to press the DOWN button within 3 seconds of power-up to select drain mode.
Instructs on setting the OFF (lower) and ON (upper) water levels for drain mode.
Details pressing DOWN to set the lower limit and UP to set the upper limit.
Steps to enter Duty Cycle setup mode and use UP/DOWN buttons to adjust the setting.
Explains that exiting setup mode is done by removing power, with settings remembered.
Explains the high limit sensor's role as a separate circuit safety backup.
Instructs to run the unit dry for 20 minutes to break in the pump before installation.
Provides tips to reduce pump vibration noise by securing the module and tubing.
Suggests replacing the power supply if no LEDs are lit.
Covers issues like rollers not turning or pump running without fluid flow.
To Next Page
