Spectrasensors SS2100 - Table 1-1 Fuse Specifications

Introduction
Hardware Installation and Maintenance Manual 1
–11
If you need to replace a fuse, use only the same type and rating
of fuse as the original. Refer also to specifications listed in
Table 1–1.
Select the replacement solenoid fuse (F2) based on the number
of solenoids installed on the analyzer.
Table 1–1 Fuse specifications
DWG Ref. Voltage Description Rating
Figure
1–6
F1
120 VAC
1 Solenoid, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.16A
2 Solenoids, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.25A
3 Solenoids, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.4A
F2 Miniature Fuse, 5 x 20 mm, Time Delay 250 VAC/0.8A
F1
240 VAC
1 Solenoid, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.125A
2 Solenoids, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.16A
3 Solenoids, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.2A
F2 Miniature Fuse, 5 x 20 mm, Time Delay 250 VAC/0.5 A
Figure
1–7
F1
24 VDC
1 Solenoid, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/0.63A
2 Solenoid, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/1.25A
3 Solenoid, Miniature Fuse, 5 x 20 mm,
Time Delay
250 VAC/2.0 A
F2 Miniature Fuse, 5 x 20 mm, Time Delay 250 VAC/1.6 A