Spectrasensors SS2000

Questions and Answers

K
Kevin HendricksJul 31, 2025
What to do if Spectrasensors Measuring Instruments show Laser Power too Low fault?
- D
  Douglas BonillaAug 1, 2025
  If your Spectrasensors Measuring Instruments are showing a 'Laser Power too Low' fault, there are several potential causes and solutions: * A loose connection in the optical head cables could be the issue. Turn off the power and check the optical head cables. * Stressed inlet and outlet tubes can also trigger this fault. Inspect these tubes to ensure they are not under stress. * It could be due to a possible alignment problem or mirror contamination. In this case, contact a factory sales representative for service information. * Alternatively, press # 6 to capture diagnostic data and send the file to SpectraSensors for further analysis.
D
Daniel LewisAug 5, 2025
Why Spectrasensors SS2000 show Pressure too Low or Pressure too High fault?
- S
  Shelly HullAug 5, 2025
  If your Spectrasensors Measuring Instruments display a 'Pressure too Low' or 'Pressure too High' fault, it could be due to these reasons: * The actual pressure in the measurement cell might be outside of the specified range. Verify that the pressure is within the correct range. * The pressure reading might be incorrect because of a loose connection or a faulty sensor. Ensure the pressure/temperature cable on the bottom of the electronics enclosure is securely tightened.
C
Cheryl BrownAug 8, 2025
What to do if Spectrasensors SS2000 Measuring Instruments show Temperature too Low or Temperature too High fault?
- P
  perrycoreyAug 8, 2025
  If your Spectrasensors Measuring Instruments are showing a 'Temperature too Low' or 'Temperature too High' fault, consider the following: * The actual temperature in the measurement cell may be outside the specified range. Check that the temperature is within the correct range. * The temperature reading may be incorrect due to a loose connection or a faulty sensor. Make sure the pressure/temperature cable on the bottom of the electronics enclosure is tight.
J
Joy RasmussenAug 13, 2025
How to deal with contamination in Spectrasensors Measuring Instruments?
- K
  Kimberly ScottAug 13, 2025
  Contamination in Spectrasensors Measuring Instruments can result from contamination in the gas sampling lines or long exposure to high humidity. To resolve this, it is recommended to periodically clean the gas sampling lines.
C
Christopher HarrisAug 17, 2025
Why is serial output providing no data from Spectrasensors SS2000?
- G
  ghornAug 17, 2025
  If the serial output is providing no data from your Spectrasensors Measuring Instruments, it might be due to incorrect settings or faulty connections. Ensure that the computer COM port is set for 19200 baud, 8 data bits, 1 stop bit, no parity, and no flow control.
N
Nathan JohnsonAug 21, 2025
What to do if front panel display is not lit on Spectrasensors Measuring Instruments?
- K
  Kathleen TorresAug 22, 2025
  If the front panel display of your Spectrasensors Measuring Instruments is not lit and no characters appear, it could be due to incorrect voltage input or faulty connections. Check for correct voltage on the terminal block input.
M
Michelle ChristensenAug 26, 2025
What to do if the reading seems to always be high by a fixed amount on Spectrasensors Measuring Instruments?
- C
  Charles HarrisAug 27, 2025
  To address the issue of readings consistently appearing high by a fixed amount on your Spectrasensors Measuring Instruments, capture diagnostic data and send the file to SpectraSensors for analysis.