Spectrasensors SS2000 - To Capture and Save Data from the Serial Port; To Read Diagnostic Data with Hyperterminal

To Next Page

To Previous Page

Operating the SS2000 System

3–16 H

S in Natural Gas

• Wet Temperature (C) - the measured operating temperature in the

spectrometer cell

• Wet Pressure (mbar) - the measured operating pressure in the

spectrometer cell

To capture and save data from the serial port:

1. To save the data from the serial port, use the Transfer/Capture

Text function and enter the Filename to where you would like to

store the captured data.

2. To stop the capture of the serial data, click on Transfer/Capture

Text/Stop.

To read diagnostic data with HyperTerminal:

1. Before entering Mode 6, make sure the serial port on the computer

used for serial communication is connected to the analyzer and the

output stream is showing on the screen as described in “To launch

HyperTerminal:” on page 3-13

The number of seconds between each line of data output should

be the Spectrum Average number set in Mode 2 divided by 4.

The factory default setting of 64 for Spectrum Average results

in a line of output each 16 seconds.