SS2000 Operator’s Manual 2–1
2 - INSTALLATION
This section describes the processes used to initially install and configure your
SS2000. Once the analyzer arrives, you should take a few minutes to examine
the contents before installing the unit. This section discusses:
• What Should be Included in the Shipping Box
• Inspecting the Analyzer and Sample Conditioning System
What Should be Included in the Shipping Box
The contents of the crates should include:
• The SpectraSensors SS2000 with sample conditioning system (if
applicable)
• This Operator’s Manual with instructions on installing and operating
the analyzer
• One or two (if a dual-channel unit) external serial cables to connect
the analyzer to a computer to receive and transmit data
• Additional accessories or options as ordered
If any of these contents are missing, contact your sales representative.
Inspecting the Analyzer and Sample Conditioning
System
Unpack and place the unit on a flat surface. Carefully inspect all enclosures for
dents, dings, or general damage. Inspect the inlet and outlet connections for
damage, such as bent tubing. Report any damage to the carrier.
Each analyzer is custom configured with various accessories and options.
Confirm that you have received the correct unit. If there is any discrepancy,
please contact your sales representative.
Installing the Analyzer and Sample Conditioning
System
Installing the analyzer is relatively easy requiring only a few steps that, when
carefully followed, will ensure proper mounting and connection. This section
includes:
• Hardware and Tools for Installation
• Mounting the Analyzer
• Connecting Electrical Power to the Analyzer
• Connecting the Input and Output Signals
To Next Page
Loading...
