SS2000 Operator’s Manual 3–1
3 - OPERATING THE SS2000 SYSTEM
Powering Up the Analyzer
After mounting the analyzer, connecting the gas lines, checking for leaks, and
connecting the (optional) output signal wires, you are ready to power up the
analyzer.
To Power up the Analyzer:
1. Power up the analyzer by energizing the circuit to the analyzer.
The analyzer is designed to be a stationary measuring device. It
should be securely mounted during normal operation.
The opening of analyzer enclosures is typically only required for
installation purposes. Once a system is installed, an enclosure
may only rarely need to be opened for inspection or maintenance.
However, do not open any enclosure or especially a sample cell
assembly unless directed to do so by a factory service
representative.
The laser housing labels on the flanges of the sample cell warn
about exposure to laser radiation inside. Never open the sample
cell unless directed to do so by a service representative and the
analyzer power is turned off.
The optical head has a seal and “WARNING” sticker to prevent
inadvertent tampering with the device. Do not attempt to
compromise the seal of the optical head assembly. Doing so will
result in loss of device sensitivity and inaccurate measurement
data. Repairs can then only be performed by the factory and are
not covered under warranty.
See Figure 2–1 for locating fuses. If you need to replace a fuse,
use only the same type and rating of fuse as the original.
To Next Page
Loading...
