Installation
2–2 H
2
S in Natural Gas
• Connecting the Gas Lines
• Powering Up the Analyzer
• Powering Down the Analyzer
Hardware and Tools for Installation
Depending on the particular configuration of accessories and options ordered,
you may need the following hardware and tools to complete the installation
process.
Hardware:
• Membrane separator filter (if not included)
• Pressure regulator (if not included)
• 1/2” Unistrut
®
(or equivalent) bolts and spring nuts
• Stainless steel tubing (SpectraSensors recommends using 1/4” O.D.
x .035” wall thickness, welded or seamless stainless steel tubing)
• 1/2” conduit hubs
• Conduit
• Source of plant nitrogen gas (4 SCF per hour) for purge unit(s), if
applicable
• 1/4” lag bolts or 1/4” machine screws and nuts
Tools:
• Hand drill and bits
• Tape measure
• Level
• Pencil
• Socket wrench set
• Screw driver
• 7/16” open-end wrench
Avoid jolting the instrument by dropping it or banging it against a
hard surface and do not attempt to pick up the instrument using
the sample cell as a handle as either may disturb the optical
alignment.
To Next Page
Loading...
