Tripod
1. The tripod and mount come
preassembled so setting up is easy
and you would not need any tools for
setting up the telescope. It’s
recommended to set up the telescope
indoor first to get familiar with the set
up process.
2. Spread the tripod out fully (see Fig.4)
and place the tripod on a relatively
flat ground or table.
3. Attach the accessory tray onto the
center spreader bar. Lock the
accessory tray down by tightening the
screw. (See Fig.4)
SETTING UP
FIG.4
FIG.5
FIG.6
6
ASTROLITE TELESCOPE
1. The
2. Spread
3. Attach
4. Release the tripod leg lock (see Fig.5) and fully extend the legs. You can adjust the
tripod height by raising the tripod legs. At the lowest level the height of the dovetail
receiver is about 22” (56cm) and about 60” (152cm) at its highest level. When fully
extended, the tripod looks similar to the image in Fig.6.
To Next Page
Loading...
General