Speed Queen AWNE92 - Washer Maintenance: Shipping and Motor; Shipping Materials Reinstallation; Motor Overload Protection

Shipping Plug
The plastic shipping plug should be saved and reinstalled any time
the washer is moved. The plug fits into two openings: The base open-
ing and the shipping plug opening on the boom of the movable piv-
ot dome. The plug MUST be inserted into both openings to prevent
damage to the washer. In order to accomplish this, the shipping
plug opening must be directly lined up with the base opening.
Refer to illustration below.
TLW2044N_SVG
1
2
4
3
1. Shipping Brace
2. Shipping Plug Opening
3. Base Opening
4. Shipping Plug
After the shipping brace has been installed in the lid opening, tilt
washer back enough to access base opening.
Insert shipping plug into base opening and, using the palm of your
hand, push shipping plug into washer until it snaps into shipping
plug opening.
Motor Overload Protector
The internal motor overload protector will stop the motor auto-
matically if there are too many clothes in the washtub or if a failure
has occurred within the machine’s motor. The control’s digital dis-
play will show tP. The overload protector will reset itself and the
display will then show tP, St alternately. Remove any laundry wrap-
ped around the agitator. Press the Start/Pause
buon to resume
the cycle. If the overload protector stops the motor again, remove
the washer from use and call a service person to correct the prob-
lem.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
22 Part No. 202956R4