DX FUNCTION SYSTEM DEFINITION DEFAULT
SETTING
Heating
0 Pulse width modulation
D01
control
1 On-Off 0.5ºC +/- 0.25ºC 0
2 On-Off 1.0ºC +/- 0.5ºC
Room
-3.0ºC to
Temperature offset from
D02 temperature
3.0ºC
measured temperature to 0ºC
offset compensate for any error
Sensor probe or
0 Sensor/Cylinder stat not connected
D03 cylinder thermostat
1 Sensor/Cylinder stat connected
0
connection
D03 must be set to 1 then external
Sensor probe
0 sensor be used as Air sensor. There
D04
used as air sensor
will be no internal temp measurement
or floor sensor
D03 must be set to 1 then external
0
1 sensor used for floor protection.
Internal temp is measured by stat
D05 Cooling control
1 On-Off 0.5ºC +/- 0.25ºC
2
2 On-Off 1.0ºC +/- 0.5ºC
D06 Actuator type
0 NO normally open
1
1 NC normally closed
D07 Valve protection
0 Disable
1
1 Enable
41
www.speedfitUFH.co.uk
Installation - Device Parameters
INSTALLATION
To Next Page
Loading...