Spektrum AR7100 11
EN
Binding
It is necessary to program the receiver to the transmitter so that the
receiver will only recognize that specific transmitter, ignoring signals
from any other sources. If the receiver is not bound to the transmitter, the
system will not operate. During binding the servo’s failsafe positions are
stored.
How To Bind
1. With the system hooked up and at least one remote receiver attached to
port B or R as described previously, insert the bind plug in the DATA/
BIND port.
2. Power the receiver by plugging a battery into the battery lead and
turning on the soft switch (if being used). Note that the LEDs on all
receivers should be flashing indicating that the receiver is ready to bind.
3. Establish the desired failsafe stick positions: normally low throttle, low
pitch and cyclic controls neutral. Please see the Failsafe Functions
section for more information about setting SmartSafe and PreSet
Failsafe functions.
4. Follow the procedures of your transmitter to enter it into bind mode. The
system will connect within a few seconds. The LEDs on all receivers
should go solid, indicating the system has connected.
5. Remove the bind plug and store it in a convenient place. A blue light on
the main unit and an amber light on the remote receiver should turn on
indicating the system is powered. Check servo operation.
6. After you’ve programmed your model, it’s important to rebind the system
so the true low throttle and neutral control surface positions are stored
in the receiver.
To Next Page
Loading...
Need help?
General
