Spengler CL22 - Installation and Connection Conditions; Disassembly and Disposal

9
Table Top Series
BEFORE INITIAL START-UP
Disassembly and disposal
• Disposeofthedispenserinaccordancewithregionaldisposalregulations.
• ThisdispenserissubjecttotheWasteElectricalandElectronicEquipmentDirective
(WEEE/EUdirective)andmustnotbedisposedoftogetherwithnormaldomesticwaste.
• Thepackagingismadefromvariousrecyclablematerials.Afterinstallingthedispenser,pleasecontactthe
wastedisposaldepartmentofyourlocalauthoritytocheckwhatoptionsareavailableforrecyclingthe
packagingmaterialordisposingofitinanenvironmentallyfriendlyway.
Installation and connection conditions
• WheninstallingtheappliancerefertotheSpenglerQuickInstallationGuidewhichisincludedwiththe
applianceforstep-by-stepinstructions.
• Whenconnectingtheapplianceand/orrefrigeratorunittothemainspowersupplymakesurethatthe
ratingslabel(shownabove)matchesthesupplyvoltagefortheinstallationlocation.
• Wheninstallingtheappliancerequiredfree(unobstructed)dimensionsare:
 -Behind:10cm(forhoseandpowerconnectionandventilation)
 -Above:32cm(foraccessandingredientrefilling)
 -Infront:48cm(fordooropeningandinterioraccess)
• Fortheoptimalperformanceoftheappliancethesehydraulic(domesticwaterconnection)parametersshall
notbeexceeded:
 -Maximuminletwaterpressure:500KPa(5Bar)
 -Minimuminletwaterpressure:200KPa(2Bar)
 -Maximumambientworkingtemperature:40ºC
 -Minimumambientworkingtemperature:10ºC