25
6.2 Manual test buttons
Note: These buttons are not accessible if editing a parameter in commissioning mode. The
product will return to the 'end' of the commissioning menu when these buttons are released.
AL
Alarm button
In run mode or commissioning mode, this button can be used to test the alarm relays and
the external circuits.
Valve close button
Commissioning mode only -
this button closes the valve (proportional control).
'Valve open' or 'pump on' button
Commissioning mode only -
this button opens the valve (proportional control) or switches on the pump (pump control).
6.3 Enter commissioning
Current legislation states that that in order to prevent tampering and potentially hazardous
programming errors, access to the pass codes required to enter commissioning mode should
only be available to qualified and trained personnel.
The pass code for commissioning mode is contained in the detachable section at the front of
this manual. This section must be removed after commissioning and kept in a safe,
access controlled location.
To Next Page
Loading...
Need help?
General
