IM-P505-02-US Issue 1
67
UTM20 Series Ultrasonic Transit-time Flowmeters
10.17 Setup > Options
Options Submenu Options/Descriptions
CARD TYPE
If CARD TYPE is set to AUTODETECT, the transmitter
will automatically detect when a new card is installed
and display menu for the card settings If CARD TYPE
is set to a specific communication/contact card, the
card settings will remain for that card type even if it is
not installed If a different card is installed or no card
is installed, a warning will be displayed on the Home
Screen and the card will be inactive
If CARD TYPE is set to DISABLED, then the card
connection will be disabled and the Ethernet and
contact menus will not be displayed
DISABLED
AUTODETECT
BACNET/IP
MODBUS TCP/IP
ETHERNET/IP
AUX OUTPUT
10.18 Setup > Passcode Setup > Security
If SECURITY is enabled and you exit the MAIN MENU, you must re-enter your passcode to access
the MAIN MENU again Passcode Setup offers three levels of access Read-Only access does not
require a passcode:
•
ADMIN—You must enter the fault ADMIN passcode 000000 to change security from DISABLE
to ENABLE
•
OPERATOR
•
SERVICE
Security Submenus Options/Descriptions
SET ADMIN 6-digit passcode Numeric entry
SET OPERATOR 6-digit passcode Numeric entry
SET SERVICE 6-digit passcode Numeric entry
LOGOUT TIMEOUT
1 MINUTE
5 MINUTES
*10 MINUTES
20 MINUTES
30 MINUTES
60 MINUTES
When logout occurs, the display returns to the Home Screen
To Next Page
Loading...
