Spirent C1 - SPT-C1 WiFi Connector Panels; SPT-C1 10 G;5 G;2.5 G;1 G;100 M Connector Panel

Spirent C1 and C2 Installation Instructions
System Description
14 | Spirent C1 and C2 Installation Instructions
PN 71-008959 Rev A April 2020
SPT-C1 4 x 1GbE and 802.11 AC/ACN WAVE-1 WiFi (NIC-33 and NIC-51/
NIC-52)
The connector panel is shown in Figure 7.
Figure 7. SPT-C1 4 x 1GbE and 802.11 AC/ACN WAVE-1 WiFi (NIC-33 and NIC-51/NIC-52)
The network data cables (customer supplied) connected to these ports must be as follows:
• Ethernet CAT-5 cable for the management port (Eth0)
• For test ports (1-4)
• Copper: RJ45 connector, Ethernet CAT-5e or better cable
The WiFi cables (provided in kit) connected as follows
• RF coax cable and SMA adapters to wireless device
SPT-C1 4 x 10G/5G/2.5G/1G/100M (NIC-63)
The connector panel is shown in Figure 8.
Figure 8. SPT-C1 4 x 10G/5G/2.5G/1G/100M (NIC-63)