Spitronics Simulator3 Manual
Spitronics Simulator3 Manual Ver 1.0 Page 4 of 11
3.3. Up and Down Buttons
These two buttons are mainly for TCU testing to simulate the up and down shift buttons.
The buttons are connected to the DB44 and can be used for other purposes as well.
4. Program Button
The program button is not only there to put the simulator in the correct program, it can be
used to change the RPM speed to simulate high and low speeds as well as removing RPM
from the unit to test startup or fuel relay. If the simulator is set on 0 RPM and the power is
removed for a very short time and put back on again the PRM’s will still be 0 and the unit
will switch the fuel relay driver on and then off again if there is still no RPM’s to simulate
fuel pump prime when the key is turned on.
5. Connecters
5.1. DB44
The DB44 connecter connects to the MERCURY and VENUS harnesses that will connect
to the specific unit you want to test.
5.2. 12V DC Power Jack
The Power Jack for applying power to the Simulator.
5.3. 6Way
The 6Way connecter connects to your programmer so you can update your simulator’s
firmware if there are new features available. Be sure to never upload incorrect firmware
To Next Page
Loading...
Need help?
General