10
Start up
Press and hold the BACK key (A) to switch on the instrument. Vib-
Checker always starts in the Main display.
Settings and instrument functions are selected using the arrow and
ENTER keys (B).
For all VibChecker versions, measurement is started manually from the
Measurement display, which is opened by pressing the MEASURE key
(C) from anywhere in the menu structure.
In the Measurement display, a new vibration measurement is started
by pressing the MEASURE key again. A blue pixel at the bottom of the
display indicates that the measurement cycle has started. The display
backlight then turns off until the measurement completes.
When idle, the instrument automatically and successively goes into
energy saving mode, first by dimming the display backlight accord-
ing to the user-defined screensaver timeout (for more information,
see chapter “Display contrast and screensaver timeout” in this user
guide). Next, after another twenty seconds, the backlight turns off
entirely, with the instrument still running. At this stage, reactivate the
backlight by pressing any key. Finally, after a further two minutes of
inactivity, VibChecker automatically turns off completely. Restart the
instrument with the BACK key.
The instrument can also be shut off manually by briefly pressing and
holding the BACK key.
Forcing instrument reset
Should the instrument have a lockup problem, prompt a reset by
pressing the ENTER key for approximately five seconds.
NOTE: This action does not initiate an instrument reset back to fac-
tory settings.
M
ISO
VIB
B
A
C
To Next Page
Loading...
