14
Vibration quantity and amplitude units
The selected vibration quantity (acceleration, velocity, or
displacement) affects the unit for the result shown in the
Measurement display as well as the spectrum and time
signal unit. The default setting is Velocity (VEL).
To set the vibration quantity:
1. Go to the Main display (A).
2. Use the arrow keys to navigate to the General settings
icon (B), then press ENTER.
3. In the General Settings menu, select the AVD icon (C)
and press ENTER.
4. In the first of two AVD displays (D), use the UP/DOWN
arrow keys to highlight the appropriate vibration quan-
tity and press ENTER to mark it. The second display
opens (E).
NOTE: If an ISO standard has been activated in the
ISO setup display, only VEL can be selected here (for
more information, see section ‘ISO standard setup’).
5. Using the UP/DOWN arrow keys, highlight the check-
box of the metrics to show in the Measurement dis-
play, and press ENTER to mark your choice.
6. To save the settings, use the DOWN arrow key to
highlight the SAVE checkbox and press ENTER.
To return to the Main display, press the BACK key.
A
Main display
B
D
AVD display 1/2
E
AVD display 2/2
General settings
C
To Next Page
Loading...
