SPOT TRACE - Using SPOT Trace; Replacing Batteries

4 5
POWER
One of these power sources:
 •(4)AAAEnergizer
®
UltimateLithium8xbatteries(L92)–installed
 •(4)AAAEnergizer
®
NiMHrechargeablebatteries(NH12)–soldseparately
 •Waterproof–DCPowerCablesoldseparately
REPLACING BATTERIES
1.Loosenthescrewstoopenthebackcover.
2.Install4AAAEnergizer
®
UltimateLithium8xbatteriesorNiMHrechargeablebatteries.
3.Replacecoverensuringthatthegasketislinedupandfreeofdebris.Tightenscrewswithasmall
 screwdriver.ItisimportantthatyoufullytightenthebackcovertomaintainSPOT TRACE's
 waterproofseal.
4.Keepyourbatteriesinstalled,evenwhenusinganexternalDCsourcetoensurepropersystem
 performanceintheeventthattheexternalDCsourceiscutorshouldfail
PLEASE NOTE:NiMHbatteriescannotbechargedwithintheSPOT TRACEunit.IfusinganExternal
DCsource,SPOTTracewillNOTbewaterproofunlessusingtheWaterproof–DCPowerCable
(soldseparately).
REPLACEABLE BATTERIES - CAUTION:Riskofexplosionifbatteryisreplacedbyanincorrect
type.Disposeofusedbatteriesaccordingtotheinstructions.
TO TURN SPOT TRACE ON:SimplylocatethePowerbuttononthetopofthedevice,pressandhold
thebutton;lightswillilluminate.SPOT TRACEwillperformaself-testandthenenterTrackmode
automatically.
SPOT TRACE SELF-TEST: SPOT TRACEperformsaself-testwhenyouinitiallyturnonyourdevice.
Duringself-test,alllightswillblinkgreeninanalternatingmannertoindicateself-testisinprogress.
SECTION 3: USING SPOT TRACE
Ifallvisiblelightsashred,theSPOT TRACEself-testhasfoundafailure,pleasecallSPOT
CustomerCare.
TO TURN SPOT TRACE OFF: Pressthepowerbuttonfor3seconds.WhenthedeviceleavesTrack
ModeandentersOffModefromthePowerbuttonbeingpressed, SPOT TRACEwillsendouta
messageindicatingthepowerhasbeenturnedoff.Thisistoletyouknowsomeonehaspoweredoff
thedevice.
Your SPOT TRACE is always in track mode when powered on. The lights will stop blinking after
20 minutes in order to be unnoticeable. A quick press of the power button will resume blinking
for another 20 minutes.
SPOT TRACE mountedinsideaberglass
compartmentofaboatusingtheincludedVelcro
stripandmountingbracket.Noticetheunitis
angledtowardtheskyforoptimalperformance.