1A. Basic Installation 5
Basic Installation
Wall Mount Installation
1. Make two mounting hole guide marks to match the
screw holes on the back of the device.
2. Drill two holes and insert screws (not included) at
the guide marks.
3. Tighten the screws until the heads protrude about
1/4 inch from the wall.
4. Plug in the power adapter cable and run the
power cable inside the groove, if necessary.
5. Connect the antenna. Hang the device on the
screws using the two holes on the back.
6. Push the device down until it securely locks into
place.
LED Indicator Lights
The three LED lights on the front of your device let you
know your device’s status at any given time.
Power – Color
Solid – In battery mode: Fully charged
In AC mode: Connected
Blinking – Charging battery
Solid – Battery low
Blinking – Battery level critically low or error
OFF – Battery missing or defective
Signal – Color
Solid – Strong signal
Solid – Weak signal
To Next Page
Loading...