82A. Basic Operation
⽧ Power ON / OFF (page 8)
⽧ Activation (page 8)
⽧ Setting Up Your Voicemail (page 9)
⽧ Getting Help (page 10)
⽧ Making Calls (page 10)
⽧ Answering Calls (page 11)
⽧ Reset Settings (page 11)
⽧ TTY/TDD (page 12)
Power ON / OFF
Power up the device:
1. Make sure the switch on the back of the device is
in the “Off” position.
2. Plug the power adapter into a wall outlet.
3. Plug the power adapter cable into the power
connector on the back of the device.
4. Slide the power switch to the “On” position.
Activation
To activate your Sprint Phone Connect:
1. Turn on your device.
2. The device will begin the activation process.
3. Wait 3—5 minutes for activation to complete.
4. Turn your Sprint Phone Connect off. Wait 10
seconds, and then turn it back on.
2A. Basic Operation
Note: When you turn on the device, at first the Power LED
glows green. It will then remain green or change to
red, depending on the backup battery charge. The
Signal LED will initially be off. Once your device has
acquired a signal, the Signal LED will glow green,
or red, depending on signal strength.
Note: Hands Free Activation ( HFA ) is automatic on this
device. Manual activation is usually not necessary.
To Next Page
Loading...