Operators manual MODEL 80XX Planter
page 66 of 173
Repairs to the electrical system may only be carried out by authorized
dealers.
Exercise extreme care when working on engine or hydraulics – risk of
serious burns!
In order to keep wear down to a minimum, clean the machine
thoroughly inside and outside. Non-observance of the instructions can
lead to malfunctions or premature wear. In this case the user carries
sole responsibility for any damage which occurs.
To ensure the operational reliability of the machine, prevent accidents
and avoid, damage, remove dirt, deposits and inflammable materials
from the machine on a daily basis!
Only carry out cleaning work when the engine is switched off!
Remove the ignition key!
Secure the machine against rolling away!
Protect the electrical system from moisture and dirt. This particularly
applies when cleaning high pressure cleaning equipment.
Maintenance
Cleaning after every operation
In order to deep wear down to a minimum, follow the instructions given below:
-Remove dirt, deposits and inflammable material from the machine on a daily basis.
-Inspect the machine for damage once a week and replace defective parts immediately
-Take note of and comply with the information regarding cleaning with high-pressure
cleaning equipment.
The following figure show the parts of the machine, which must be cleaned after each
use:
To Next Page
Loading...
