Operators manual MODEL 80XX Planter
page 67 of 173
Maintenance
Parts to be cleaned
Cleaning with high-pressure cleaning equipment
Clean the machine thoroughly, inside and outside. Dirt attracts moisture and leads to corrosion. The
following advice should be adhered to when using high-pressure cleaning equipment to wash down the
machine:
Cleaning instructions:
During the first six weeks do not wash down the machine with high-pressure cleaning equipment.
Thereafter:
-Do not direct the jet of water at bearings.
-Do not direct the cleaning jet towards electrical/electronic components.
-Only use a wide-jet nozzle; machine nozzle clearance to be min. 600 mm (2ft).
-Always keep the wide-jet nozzle moving from side to side.
-Nozzle spraying angle min. 25degrees.
-Spraying pressure max. 1450 psi.
-Water temperature max. 68 degrees Fahrenheit.
-Do not use any cleaning additives.
To Next Page
Loading...
