SPX FLOW APV DELTA SD4 Series User Manual

23
APV_SD4_ATEX_UK-0_122018.indd
UK
Double seal valve
DELTA SD4-ATEX
Instruction Manual: UK - rev. 0
APV
14. ReconstructionofActuator
With SD4 valves, the size of the actuator can be changed.
Observe the respective line pressure, see table 9.6,
to increase or decrease the actuator sizes
(Ø 74 mm, Ø 110 mm, Ø 165 mm).
14.1. Reconstructionofactuator
 Disassembly
Disassembly is carried out as described in chapter 11.
To change the actuator size, the respective guide rod
must be replaced:
 Attention!
Clamp the valve disc in a vice.
The valve disc must not be damaged (use protective cheeks or
cleaning rags).
Even inferior damage at the shaft rod can lead to leakages.
Turn the guide rod out of the shaft by means of the centering
washer and a wrench SW17.
14.2. Assemblyofactuator
1. Turn the respective guide rod into the shaft to the actuator.
Tighteningtorque40Nm
2. Further assembly is undertaken in reverse order.

SPX FLOW APV DELTA SD4 Series Specifications

General

Brand	SPX FLOW
Model	APV DELTA SD4 Series
Category	Control Unit
Language	English