Spypoint FLEX-M - Regulation

26
FLEX SeriesSPYPOINT
Regulation
FCC STATEMENT
Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
CE STATEMENT
Herby, SPYPOINT declares that this trail camera model FLEX Series is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU. In accordance with Article 10(2) and Article 10(10), this
product allowed to be used in all EU member states.
Use the FLEX Series in the environment with the temperature between -1°C and
35°C.
IC STATEMENT
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
The term “IC:“ before the certication/registration number only signies that
the Industry Canada technical specications were met. This product meets the
applicable Industry Canada technical specications.