8
FLEX SeriesSPYPOINT
Power Supply
CHOOSING A POWER SOURCE
FLEX-S only - It's not required to add additional power sources to your
camera, but you may want to extend the overall time between visits.
4 options are available to you:
• Alkaline or lithium AA batteries
• Rechargeable battery 12 V (#KIT-12V sold separately)
• Rechargeable battery pack 7.4 V (#LIT-22 sold separately)
• Solar panel lithium battery 12 V (#SPLB-22 or #SPLB-10 sold separately)
FOR BEST RESULTS AND NO LEAKAGE
• Do not mix new and old batteries.
• Always purchase the correct size and grade of battery most suitable
for the intended use.
• Replace all batteries in a set at the same time.
• Clean the battery contacts and those of the device prior to battery installation.
• Ensure that the batteries are installed correctly with regard to polarity (+ and -).
• Remove batteries from equipment that is not to be used for an extended
period of time.
• Remove used batteries promptly.
• Do not use rechargeable AA batteries (their lower voltage will generate
operational issues).
• When batteries of dierent brand or type are used together, or new and old
batteries are used together, some batteries may be over-discharged
due to a dierence in voltage or capacity. This can result in venting, leakage,
and rupture and may cause personal injury.
HOW TO INSTALL AA BATTERIES PROPERLY
• Unlock the latch and open the FLEX door.
• Place the battery holder back into the battery
compartment with arrows facing up (See Photo)
• Insert the AA batteries into the battery holder
following polarity (+) and (-) indications.
• Place the battery holder back into the battery
compartment.
SPLB-22 OR SPLB-10:
SOLAR PANEL LITHIUM
BATTERY COMBO UNIT
• Combines solar panel and lithium
battery into one unit to reduce wires
and setup time.
• Plugs directly into camera to provide
extensive, ongoing battery life for
your camera so you can avoid visits.
• Additional jacks and plugs allows for
device exibility.
To Next Page
Loading...
