Spypoint FLEX-M - Before Your First Use, Charge The Internal Battery; Operation

7
FLEX SeriesSPYPOINT
Power Supply
BEFORE YOUR FIRST USE, CHARGE THE INTERNAL BATTERY
• Ensure the camera is powered OFF
• Plug the charging cable (12 V DC connector) to the camera.
• The status light will illuminate red while charging and turn OFF when fully
charged.
• It is recommended to charge the battery fully (approximately 12 hours).
OPERATION
• The solar panel is not an autonomous power source for your camera.
Its only function is to maintain the charge of the internal battery or to slowly
charge it. The solar panel will be eective as soon as ambient solar energy
is detected.
• Make sure there are no objects or elements obstructing the solar panel
(e.g.: snow). If it is partially covered, the solar panel will still work, but to a
limited extent. For optimal performance, it must be completely clear.
• Under optimal conditions (a conguration that consumes little energy), the
energy and a sunny environment), the power supply of the camera will be
autonomous.
• If your internal battery runs out, the camera will shut down unless you have
a secondary power source (e.g.: LIT-22, AA, 12V, ect.).
• If the camera turns OFF, the solar panel will continue to charge the internal
battery. Charging by solar power only can take an extended amount of time
- for a quick and complete recharge, connect the camera to a wall outlet
using the supplied USB cable and a USB power adapter.
• When you restart your camera, after recharging the internal battery,
it will return to the settings you previously selected.
flex-s only