Spypoint FLEX-M - Power Supply; Managing Various Camera Power Supply; Battery Usage

9
FLEX SeriesSPYPOINT
Power Supply
MANAGING VARIOUS CAMERA POWER SUPPLY
If you choose to plug an external 12V battery (SPLB-22, SPLB-10 or KIT-12V,
sold separately) into your camera, it becomes your camera's new primary
power source. The AA batteries will only be used once the 12V battery is
depleted.
FLEX-S only: the cameras primary power source is the internal battery, once
the internal battery is depleted, the camera will default to the 12V and then to
the LIT-22 or AA's installed in the battery tray.
You can check the battery level on your device or in the mobile application:
• In the application: on the home page, you will see the battery charge level
for each of your devices. You can access more details on the status of your
battery by going to the STATUS page. When the battery logo turns red, we
suggest that you change the batteries before it is completely drained.
• Once the device is powered on. There are four green lights within the battery
icon indicating the battery level. Your Flex + has two battery slots.
FLEX-PLUS ONLY
You can use them in any conguration with compatible batteries.
Please check the chart below to conrm compatibility.
BATTERY USAGE
• The camera will use rechargeable power sources before AA. In the event
that you are running two sets of AA batteries, the set with the lowest
capacity will be used rst. The same scenario applies to using two LIT-22’s.
The camera will use the lowest capacity battery rst and then switch to the
second battery after it has been depleted.
• Should you decide to also add an external battery using the 12V port of the
camera – The camera will prioritize the 12V power rst and only when it is
depleted will it use the batteries located in the Slots.
SLOT 1 SLOT 2
AA LIT-22
LIT-22 AA
AA AA
LIT-22 LIT-22
ANY NONE
NONE ANY